Jatoba Klötzchen Restposten

The mini drilling rods we offer fit into this holder for mini drilling rods. The holder is made of 12 mm square material and therefore also fits into steel holders on smaller lathes. The boring bars are inserted into the holder and fixed with an M4 hexagon socket screw. The holders also fit into the tool holders of very small lathes. Dimensions Holder for mini boring bars Height: 12mm Width: 12mm Length: 60mm

The finger engine Empire has been specially designed by us so that the material kit can be worked, assembled and painted in less than 6 hours. Therefore, the pedal machine is very good if you want to give a close relative, a good friend or a good model builder a model you have built. Of course, the "Empire" can also build for themselves. The "Empire" finger engine is a great model for the desk of every technology fan. By moving a finger up and down, we press the pedal and bring the machine to life. The machine is held in motion by actuating the drive pedal. The constant actuation of the finger pedal has a very calming effect on the user. In addition, we recommend using the pedal machine during long telephone conversations to increase the well-being (guess of the designer). The finger engine is held in the Art Deco style of the 1920s. The finger engine is mounted on a Jatoba base plate The skin wave is ball bearing. Most components of the Empire are made of brass. The flywheel is made of cast steel. Scope of delivery finger engine "Empire" Material kit Machined wooden base plate Finished milled parts Raw material for the turned parts Very clean 80mm cast flywheel All required screws, ball bearings and maggot screws Planter pedal machine "Empire" Drawings (3 sheets) and construction manual (1 sheet) Dimensions Pedal machine "Empire" Material set Height with base plate: 130mm Width with base plate: 135mm Flywheel D .: 80mm Only a few tools are required to build the "Emipre" foot pedal. A small turning machine and a small drill are perfectly adequate. In addition, a gas burner should be provided for softening large parts. M3 and M4 taps and M3 and M4 cutters are also needed. Furthermore, reamers 4H7, 5H7, 6H7 and 10H7, file and a drill set are necessary.

These glass oilers for model making are made from brass. The sight glass is made of impact-resistant acrylic glass. Both sizes have a connection thread with an M3 meter standard thread. The glass oilers have a fixed flow rate. The flow hole is 1.0mm. The oilers are designed as cup oilers and do not have a top lid. The real glass oilers can be installed on cylinders of flame eaters and Assemble Stirling engines. Of course, the glass oilers also look very good on eccentrics, bearing blocks of steam engines or internal combustion engines. The oilers are available in 2 different sizes. Dimensions of glass oiler 6mm cannot be adjusted Total height: 20.5mm Diameter glass: 5mm Largest diameter: 6mm Connection thread: M3 Dimensions of glass oiler 8mm cannot be adjusted Total height: 27mm Diameter glass: 7mm Largest diameter: 8mm Connection thread: M3