TurboPlane Frässcheibe 100mm

Der Industrial Woodcarver von Arbortech ist die Weiterentwicklung vom klassischen Woodcarver. Der Vorteil dieser Frässcheibe ist das die Klingen aus Hartmetallplättchen bestehen. Die runden Hartmetallplättchen können 2-3 Mal gedreht werden, so dass Sie immer wieder scharfe Klingen zur Verfügung haben. Selbst härteste Hölzer sind somit kein Problem. Sogar einen im Holz eingewachsener Stahlnagel macht dem Industrial Woodcarver nichts aus. Wenn die Plätzchen komplett stumpf sind, bekommen Sie bei uns natürlich als Ersatzteil. Aber keine Sorge die Lebenszeit der Hartmetallplättchen ist 25 mal länger, als die der Schneiden des normalen Pro-4 Woodcarver von Arbortech. Der Industrial Woodcarver verwandelt Ihren Winkelschleifer in eine Holz Fräse. Er passt auf alle gängigen 100mm und 115mm Winkelschleifer. Er wurde speziell für den professionellen Anwender designt. Der Industrial Woodcarver ist die professionelle Wahl, wenn es um Freihand Holzschnitzen geht. Die Hartmetallklingen des Woodcarver schnitzen das härteste, als auch das weichste Holz mit gleicher Glätte, Effizienz und Kontrolle. Je härter das Holz ist, desto besser funktioniert der Industrial Woodcarver.

Connecting sleeves for soldering into the steam boiler with two different fine threads. The soldering connection sleeves are inserted into a hole with a 10 mm diameter and can then be soldered hard or soft. The beeches are made of brass MS58. Thanks to the soldering connection sleeves, the parts attached to the steam boiler have a sufficiently stable and long screw-in thread. The solder connection sleeve M6x0.75 fits our boiler accessories.The solder connection sleeve e M8x0.75 fits our safety valve with weight  The socket dimensions are always the same: Soldering diameter: 10mm Bundle diameter: 12mm Height: 10mm

When brazing, fluxes have the task of loosening and removing the oxide layers present on the soldering surfaces and preventing them from forming again during soldering. The flux is adjusted to the working temperature of our Silver hard solder matched. Before use, the flux for silver solder should be stirred well. Using the brush in the bottle, a thin layer can be applied to the component to be soldered. You can find detailed instructions in our model making magazine (Hard soldering with silver solder instructions). If the silver brazing flux has dried out, you can make it liquid again with distilled water. Brazing with silver solder rods without flux is not possible. When the flux is heated with the burner, the water it contains first evaporates. This can be seen in the final formation of small bubbles. When the component is heated further with the flux and the working temperature is reached, the flux paste begins to melt and becomes transparent. Now the moment has come where the silver solder can be added. The effective range of the flux for silver solder is between 500°C and 800°C. The flux is suitable for brazing copper, brass, gunmetal, steel and stainless steel. Tip: Flux residues and discoloration of the material can be optimally removed with our Satin brushes or remove with abrasive fleece. You can get the flux for silver solder from us in the packaging sizes: 50g. Bottle with brush 100g.Bottle without brush

Fill up your leftover box!!! With these 800g brass scraps you always have a little spare material on hand.   You get 200g of Ms58 flat material between 2mm and 6mm thick and  600g Ms58 round material between 3mm and 50mm diameter. The exact composition is of course always different.