Marking gauge

Marking gauge analog

This sturdy analogue marking gauge in stainless steel version is outfitted with a replaceable hard metal-mounted tear-off needle. The resolution of the dial gauge is 0.01mm. The largest dimension to measure is 310mm.

Due to the adjustment wheel attached to the back, every dimension can be set very quickly and cleanly. The marking unit can be fixed by means of a locking screw. The analog dial gauge has a diameter of 55mm and is therefore very easy to read. The dial gauge is rotatable. A further great advantage with the analog variant of the marking gauge is that it does not need batteries.

The 2 counters for full millimeters can be set to zero. If you want to draw a hole pattern with only the hole spacing, place the needle in the center of the workpiece, zero the counters, and move the needle to the desired height up and down.

Digital marking gauge

The stainless steel digital marking gauge has a replaceable hard metal pin.

The division of the digital scale is 0.01mm. The largest dimension to measure is 310mm.

The marking unit has a second carriage for fine adjustment. Both slides have a fixing screw for fixing. The digital unit can be changed from mm to inch. In addition, an absolute zero point and an incremental zero point can be set. The incremental zero point is required if you want to draw a hole pattern in which only the hole distances are dimensioned. The needle in the center of the workpiece will have incremental zeros, and now move the needle to the desired height up and down. After that, you will return to the absolute measure and you have again the distance between the drawing pin and the marking plate.