Model steam engine "Danni" premilled material kit

The stationary steam engine "Danni" model includes a sturdy frame to which the dual action steam cylinder attaches. The steam engine's cylinder is controlled by a cam and a round valve. This compact yet powerful steam engine is great for steam boiler operation but can also be operated by compressor.

Careful fabrication of this assembly and without load the engine will already start at 0.1bar. The steam engine's plan and construction manual are very extensive, detailed and written to be easy to follow. The model steam engine's cylinder is brass, the piston bronze. Plungers and valves are made from stainless steel, the flywheel is cast iron. All remaining parts, as customary for steam model making, are brass.

The delivery volume consists of:

• finished-machined milled
• Raw material for the rotating parts
• Cast part for Flywheels
• Cast part for beam -
• Material & valve ball to produce a feedwater pump
• Milled-wood base
• All necessary nuts, bolts and ball bearings
• Drawings beam engine 'Danni' (9 sheets) and instructions (6 sheets)

Dimensions

• Total High: 100mm
• Base plate: 140mm x 100mm
• Piston Dia.:15mm
• Stroke: 18mm
• Flywheel D.: 80mm

Building the material kit for the "Danni" steam engine only require a few tools. A small lathe and a small power drill will do. Your lathe should be large enough to overwind the outside of an 80mm flywheel. You should also have a gas torch for soft soldering larger parts. You will also need M2 and M3 screw taps and M2 and M3 threading dies, reamers 4H7, 6H7, files and a drill bit set.

Productvideo Steamengine Danni