Flame eater "The big Nick" Premilled material

The vacuum motor or flame licker 'The large Nick' mainly consists of brass. It possesses water-cooling with an evaporator container. The flywheels are made of cast iron. The large Nick is mounted onto a Jatoba wood plate. The crankshaft and the slide shaft have ball bearings. It runs at approx. 200-300 rpm. The burner is adjustable in height, so that the speed can be regulated over the handhweel. In addition, the distance from the flame to the cylinder head can be adjusted over a handwheel.

All milled parts have already been processed and must be partially drilled yet. All rotating parts are yet to be filmed in its raw state and need. The construction of the fire-eater and the burner necessary materials, screws, ball bearings and spring elements are included in the kit.

All necessary materials for the construction of fire-eater (screws and spring elements) are included in the kit.

The construction of the fire-eater, a medium sized lathe (minimum quantum D is x 250 400), a drill and a gas burner required for soldering larger parts and a torch for brazing small parts. Otherwise, are still hand tools, which should be in every "steam engine workshop" (Taps M2, M3, M4, M8x0, 75 cutting dies M3, M4, M8x0, 75 Reamer 3H7, 6H7, 10H7, files, drill bit) needed.

If you have any tools for making the flame-eater, "The Big Nick" need, simply click the required items and you will be automatically redirected.

Dimensions flame eater The big Nick

• Length: 260mm
• Width: 150mm
• Height: 240mm
• Flywheel D.: 140mm
• D. Piston: 26mm
• Stroke: 46mm 

The delivery volume consists of:

• -Finish-machined milled
• -Raw material for the rotating parts
• -Cast iron flywheels
• -Milled-wood base
• -All necessary screws, nuts, ball bearings and spring elements
• -Blueprint flamelickers Drawings (8 sheets) and instructions (6 sheets)
• -Burner blueprint drawings (3 sheets) and instructions (2 sheets)
• -Large burner kit 2-axis adjustable

Flame eater "The big Nick" Premilled material